KR939SB3 three parameter combination (oil level temperature vibration combination) probe is a general type combined probe that is used in cooling tower fan safety monitoring system. It can be connected with a variety of general two instruments, or computer data acquisition and control system (DCS, PLC, etc.).
This is applied to the fan gear box combined probe for safe operation of monitoring, in its internal integrated measuring temperature, oil level, vibration signal sensing, conversion and transmission circuit of direct output and the security parameters corresponding to the 4 ~ 20mA standard current signal, can be matched with a variety of general-purpose two meter or computer digital acquisition monitoring system.
The probe temperature measurement with platinum resistance sensor and semiconductor integrated device; level measurement using a capacitive sensing principle; sensor for measuring vibration, mechanical vibration acceleration signal acquisition, band-pass filter, an integral and true effective value through the amplifier (RMS) converter, the vibration waveform in the effective bandwidth of it effective value conversion; finally, the oil temperature, vibration generated by the 4 ~ 20mA output.
Main technical performance and indicators
External and installation structures;
KR939SB3 three parameter combination probe, the probe is an external thread form, is installed in the threaded installation hole of the fan reduction box, and the probe rod is inserted into the reduction box, so as to get the lubricating oil temperature, the lubricating oil level and the box vibration signal in the reduction box, and complete the transformation output. Thread specifications and probe inserts need to be declared at the time of order. See Figure1.
[figure 1] exterior pattern
Temperature measurement characteristics;
Measurement range of lubricating oil temperature：0～100 ℃ ，Compreh
-ensive error of temperature measurement：±1℃
Oil level measurement characteristics:
Measurement range of lube oil level：0～50㎜（10 mm for the gear box under normal oil level oil limit position）, Maximum error of oil level measurement： <= ±1㎜
Ambient temperature from -40 to 65 C（Extreme temperature resistance from -50 to 150 C）
Vibration measurement characteristics：
Range of vibration measurement：0～20 ㎜/s ，The measurement output is proportional to the effective value of the vibration velocity (RMS). Frequency range of vibration measurement: 10～1000HZ, Maximum error of vibration measurement: <=±1㎜/s
Signal output characteristics;
Active current type output：DC/4～20mA ，Requirements for passive resistive load。Maximum load resistance：< 300 Ohm
Supply characteristics of power supply：
working voltage：DC/24V±4V，Maximum protection voltage：DC/30V ，Rated current：DC/80mA, Maximum instantaneous working current：120mA，Internal voltage Ambient temperature range：－20～80℃，Ambient humidity range：0～100％（The port is sealed with 704 silicone rubber seals）
Electrical connections：
Two four bit terminals：+24V power supply、GND、It 、t-COM、Io、o-COM、Iv、v-COM：It temperature current signal output；Io oil level current signal output；Iv vibration current signal output：The typical connection refer to the schematic diagram of the connection principle of the probe
JM-B-3Z-02-02-200智能振动监测?；ひ?br style="margin: 0px;"/>智能转速表HZS-04
一体化振动温度变送器VRT-2T
正反转监测?；ひ荲B-Z470B（S2184）
一体化振动变送器VIB-100
CS-1-G-075-03-01转速探头
VB-Z9500振动速度传感器
VB-Z500B 旋转机械状态监测?；け?br style="margin: 0px;"/>VB-Z8600超速（转速）校验仪
VB-Z8901振动校验仪
HZD-B-S振动变送器
HZD-B-5X一体化振动变送器
VB-Z470正反转监测仪
VB-Z440转速监测仪
VB-Z470智能反转速监测表
XZD-YB 一体化防爆振动变送器
CD-21-T振动速度传感器
CD系列速度传感器CD21-C CD21-S
TS-V-211智能振动温度监测仪
HZS-04T-S挂壁式智能反转速表
振动烈度监测?；ひ牵ū诠沂剑?br style="margin: 0px;"/>SWZQ-3A风机监控报警器
JM-B-3Z智能振动监测?；ひ?br style="margin: 0px;"/>HZD-W/L-F 型振动/烈度监测?；ひ?br style="margin: 0px;"/>CZJ-B振动监测?；ひ?br style="margin: 0px;"/>CZJ-B2/B3/B4 智能振动监视仪监控仪
CZJ-B3系列振动监视?；ひ?br style="margin: 0px;"/>MLI-2001双通道振动监控仪
HZD-W/L-F智能振动监控仪
CZJ-3N振动监测?；ひ?br style="margin: 0px;"/>HZD-W/L型四通道振动监控仪
RDXZ-2/2N/2NA轴振动监视仪
UT312 测振仪
CZJ-B系列振动监视?；ひ?br style="margin: 0px;"/>DYZ-L型振动烈度监控仪
DYZ-Z型振动烈度监控
振动数显报警器ＫＹＳＸ－２０００
振动组合探头ＫＹＺＤ－３０００
三参数组合探头KR－939SB3
SDJ-101位移振动?；け渌推?br style="margin: 0px;"/>SDJ-301轴向位移变送器
VB-Z230，VB-Z230AN振动变送器
普林斯顿PR-9200机壳振动变送器
JK9301B01一体化振动变送器
SDJ-302轴位置?；け渌推?br style="margin: 0px;"/>TD-9200A 一体化振动变送器
VRT-2（T）型振动速度（及温度）变送器
SWZT-1F/A分体式振动温度变送器
KR-939SB3型一体化
KR-939SB4型一体化四参数组合探头
ST-3振动速度传感器
HZD-B-9F 振动变送器
HZD-B-6两线制一体化振动变送器
HZD-B-Ⅰ型振动变送器
HZD-B-S振动变送器
HZD-Z-7型轴振动变送器（带触点输出）
HZD-B-9型振动变送器
HZD-B-5T 一体化防爆振动变送器
HZD-B-8T/HZD-B-8B/振动变送器
HZD-B-4一体化振动变送器
HZD-B-1 振动变送器
HZD-B-8一体化振动变送器
HZD-B-5一体化振动变送器
HZD-B-9/HZD-B-9F振动变送器
KR－939SB3特点：
二线制振动速度传感器SDJ-SG-2
振动速度传感器HD-ST-2
HD-ST-3振动速度传感器
YD9200A系列一体化振动变送器
ZHJ-402一体化振动温度变送器
ZHJ-201振动温度传感器
JM-C-7F正反转速监测仪
JM-B-3Z/N振动监测仪
JM-C-3转速监测仪
JM-B-3Z振动转速监测?；ひ?br style="margin: 0px;"/>JM-B-7 智能振动监测?；ひ牵ㄋǖ溃?br style="margin: 0px;"/>振动变送器ST-3
ST-2振动速度传感器
SG-2振动传感器
ZD-01振动变送器
ZD-02型烈度振动变送器
ZD-03型一体化防爆振动变送器
ZD-03A一体化振动变送器
ZD-05一体化振动温度变送器
ZDI-01型轴振动变送器
YC-DO型胀差变送器
YZ-DO型轴向位移变送器
CZY-01型转速变送器
YTD-1型位移变送器
壳振动速度传感器
压电式一体化振动变送器
一体化振动传感器
ICP压电加速度传感器
一体化带显示振动变送器
上一篇 : 轴承振动测量仪的校准方法工作原理
下一篇 : 智能转速监控仪工作原理
